Pan-Fried Ribeye Steak
Pan-fried ribeye steak is all about a very hot pan, a dry surface and not fiddling with the meat. Ribeye has plenty of marbling, so it forgives a little extra heat and builds a dark crust quickly. Butter, garlic and rosemary go in after the turn and are spooned over the steak to finish it. Rest it for five minutes and the juices stay where they belong.

- Total
- 50 min
- Prep
- 5 min
- Cook
- 10 min
- Serves
- 2
- Per serving
- 715kcal
Internal temperature and resting for pan-fried ribeye steak
A thermometer takes the guesswork out. Take the steak off the heat at 48–50°C for rare, 52°C for medium-rare and 57°C for medium, because it climbs a few degrees as it rests. A whole steak like this can be served pink, since any bacteria sit on the outside and the sear deals with them. The five-minute rest lets the juices settle so they do not run across the board when you slice.
Step-by-step pan-fried ribeye steak
Tap a time to start a timer.
- Bring to room temperature Take the steaks out of the fridge before cooking. Pat them very dry with kitchen paper, then season both sides and the fat edge with salt and pepper just before they go in the pan.
- Heat the pan Put the pan over a high heat for about , switch on the extractor fan and add the oil. It should shimmer and just start to smoke.
- Sear Lay the steaks in the pan, away from you. Cook for without moving them, until the underside is dark brown.
- Turn and baste Turn the steaks, lower the heat to medium and add the butter, garlic and rosemary. Cook for , tilting the pan and spooning the foaming butter over the meat. For medium-rare take them off at 52°C on a thermometer; for medium cook for and take them off at 57°C. Stand each steak on its fat edge for a minute to render it.
- Rest Move the steaks to a warm board, cover loosely with foil and rest for . Slice across the grain and pour over the pan butter.
Cuts and what to serve
Ribeye is the richest steak, so a simple side works best. If you would like a leaner, cheaper cut cooked the same way, try pan-fried bavette. No hob to hand? The air fryer ribeye steak gives you a similar result with less smoke.
Common problems and fixes for Pan-Fried Ribeye Steak
- The steak is grey instead of browned.
- The surface was wet or the pan was not hot enough. Pat the meat dry, wait for the oil to shimmer and cook the steaks one at a time if your pan is small.
- The kitchen fills with smoke.
- Some smoke is normal with a very hot pan, so use the extractor fan. Choose rapeseed or vegetable oil, which can take the heat, and add the butter only after turning the steaks.
- The steak is tough.
- It was cooked past medium or cut with the grain. Take it off at 52–57°C, rest it for 5 minutes and slice across the muscle fibres.
- The steak is thinner than 2cm.
- Cook it for 1½–2 minutes a side, because the middle heats through very quickly. Check with a thermometer rather than the clock.
Frequently asked questions about Pan-Fried Ribeye Steak
How long do you cook ribeye steak for medium-rare?
Cook a 2.5cm steak for 3 minutes on each side in a very hot pan, then rest it for 5 minutes. A thermometer should read 52°C when it comes off the heat.
Should you bring steak to room temperature first?
Yes, leave it out for about 30 minutes so it cooks evenly. Do not leave it out for longer than that, and keep it covered.
What is the best oil for frying steak?
Use rapeseed or vegetable oil, which have a high smoke point. Add the butter after turning the steak so it does not burn.
Can you use a non-stick pan?
You can, but a heavy stainless steel or cast-iron pan gets hotter and builds a better crust. Many non-stick pans should not be heated empty on a very high heat, so check the maker's advice.
How did you like the recipe?
4.9 / 5 · 29 ratings



